When winter comes and you are no longer going to spend time out on your boat and you need to find a way to find the correct class of storage for his boat.

There are many advantages that will store your boat correctly and while it may take a little time to get the job done right by following good boat storage not only saves money but also a lot of tension.

Below you will find a few tips that need to be followed to ensure that your boat has been stored correctly and you will need the following equipment for your body is ready for storage.

1. Oil storage / moisture

2. Fuel Stabilizer

3. Aerosol Anticorrosion

4. Lubricant Aerosol

5. Trailer Jack

6. Tools

The first thing we’re looking at is fuel stabilizer that helps to stop condensation forming in the fuel tank and fuel lines and therefore it need to be added to a tank full of gas first. When adding the fuel stabilizer is important that you follow the manufacturer’s instructions to the letter. Now turn the engine on the machine rinse for about 1 minutes to push the treaty through the fuel system of fuel.

Now we come to the fogging oil that is applied to the carburetors. You’ll find that most of the ship’s engine mountings have to apply the oil to be tarnished. However, if yours does not have such a fitting then you need to find openings where the oil can be applied (you may even have to remove the cover of the carburetor to do this). However, what you must remember is that oil is the engine that will tarnish the ship smoke more than normal when you work the first time.

You need after Zafar machine rinse and drain the gear box and then fill it with fresh lubricant. If you happen to notice the water in the grease cleaned with a water jet that can be a sign that the shaft seal must be replaced. It is important to remember that a stamp mai n if not replaced could cost $ 1,000 or more in repairs.

The spark plugs must be removed and oil fogging spray in the cylinders, also to clean the deck and cover electrical connections with an anticorrosion spray. Also replace the spark plugs removed for new.

You should review the management and all the cables in the column after handling and cleaning out any dirt and then leaves out the vent shaft. Make sure all cables have been using aerosol spray resistant.

Now you need to disconnect the battery and clean all the terminals and spray them with liquid anti-corrosion and then stored. Also remember to put the slope in the load UCES couple of days each month while the boat is in storage.

The engine of your boat must lean down on the current position and covered with a casing of the engine. It is important that you do not use plastic to cover the engine because the trap moisture against the engine instead of the other uses a cloth or canvas bag (it allows

Travel motoring breathing).

If your boat is stored on a trailer and it looks completely grease all the bearings in it. Also check the tires and spray any unprotected piece of metal or iron with a spray-resistant.

Now you have stored your boat by following the tips on you can relax and look forward to season after.